Page 2 of 2

Re: Aaagh the 3 amigos have arrived

Posted: Sat Dec 19, 2015 11:24 am
by mudmagnet
Davey Boy wrote:Sounds like your zeroing in on on the prob Gav. :gr8:

It's a learning curve davey

Re: Aaagh the 3 amigos have arrived

Posted: Sun Dec 27, 2015 1:18 pm
by Spooky
It could be the hub (bearing failing, allowing the shaft to move), or (as it was in my case) a broken wire on one of the sensors.

Looking at the 'live' voltage readings found the fault for me ...

Re: Aaagh the 3 amigos have arrived

Posted: Sun Dec 27, 2015 8:15 pm
by ozzy57
It is the bearing on its way out.

Re: Aaagh the 3 amigos have arrived

Posted: Mon Dec 28, 2015 4:19 am
by mudmagnet
As the little Mexicans came boinging back yesterday I'm going to have to get the hub done soon

Re: Aaagh the 3 amigos have arrived

Posted: Mon Apr 04, 2016 3:17 pm
by mudmagnet
Finally got round to changing the rear hub today
There was no play in the bearing but it felt rough when rotated and it was a real struggle to get the halfshaft separated from the hub as the person who changed it last time must of had shares in loctite as the splines were covered in it, anyway new hub fitted new brake pads and the 3 amigos have gone for now (fingers crossed )
Image
Image
Image

Re: Aaagh the 3 amigos have arrived

Posted: Mon Apr 04, 2016 3:34 pm
by littlejimny
Well done, fingers crossed !

Re: Aaagh the 3 amigos have arrived

Posted: Mon Apr 04, 2016 5:02 pm
by Davey Boy
Tidy job Gav! :gr8: